Chi-you clone not firing?

[wutermelon]

I posted a thread saying my igo-w wasnt firing as hot but i put it on my k100 and it wasnt my igow at all it was my chi you clone.
The clone barely fires at all and I adjusted every pin. I have a feeling its broken but its not damaged at all. I had it few a few monthes now and it was working fine back then. Help?

 

[Jimi D.]

Make sure everything is tight. There's nothing to a mech. Check if the battery rattles. Make sure that the positive pin has a tight connection to the atty.

 

[wutermelon]

Idk if this sounds silly going back to it. But could it be the igo-w just dying out in general? I had it for a while now...

 

[Jimi D.]

Idk if this sounds silly going back to it. But could it be the igo-w just dying out in general? I had it for a while now...

Just make sure everything is tight, and it should be good to go. I have atties that's close to 2 years now.

 

[mogium]

Have you tried cleaning the contacts on the top and bottom

 

[Jimi D.]

What's the wire gauge, resistance and how many wraps ?

 

[Doghead]

Just send it to me and if I can't fix it, I'll send it back.


Sent from my iPhone using Tapatalk

 

[wutermelon]

What's the wire gauge, resistance and how many wraps ?

Fixed it again by doing what you said. But I have to say sometimes it works and sometimes it doesn't It can be annoying its never done this before. 6 wrap single coil 26g with cotton wick

 

[classwife]

Moved to APV Discussion from the Modding Forum