Clearomizer broke =/

[Kenneh]

My clearomizers just came in the mail, and as I was putting one on the plastic case shifted, and now the thing just won't atomize anymore. The liquid is too thick for me to tell if it shifted enough to screw up the wiring(if thats even possible). Almost spilled 1mil all over myself, but managed to keep the plastic over the male end. Basically my question is: is there anyway to fix this, or am I just going to have to be more careful in the future and toss this one out?

Thanks in advance.

 

[Parmacrafter]

Replacement tubes can be bought at Madvapes They are out of stock at the moment but should have more shortly. It is always a good idea to have spare tubes on hand if you are going to be using clearomizers. I would empty the one you are using and set it aside until you can get some spare tubes. It is also possible that either your center pin got pushed up and is no longer making contact with center of your atty connector, or that one of the wires broke when it twisted.

 

[K24A3]

Apply some sticky tape around the base of the carto near the threads, that should strengthen it significantly.

But I've gone back to the metal ones for now since I'm not keen on babying the plastic ones all the time.

 

[lemonshrew]

But I've gone back to the metal ones for now since I'm not keen on babying the plastic ones all the time.

Babying is right! I got a 5-pack of clearomizers last Monday. Of the 5, 2 have already stopped working. One cracked and the other looked like it was burnt out (whatever the cause, it just stopped working). With the remaining 3, the vapor decreases rapidly after about 15 minutes of use, so I have to pull out the mouthpiece and the white ring, and use a napkin to clean out any juice that has seeped into the top part to get them working again. The vapor and flavor of these things is great, at first. But, I don't even bother trying to take them with me when I leave the house.

 

[Stownz]

First 5 I bought broke, never bought them again.

 

[Credo]

My clearomizers just came in the mail, and as I was putting one on the plastic case shifted, and now the thing just won't atomize anymore. The liquid is too thick for me to tell if it shifted enough to screw up the wiring(if thats even possible). Almost spilled 1mil all over myself, but managed to keep the plastic over the male end. Basically my question is: is there anyway to fix this, or am I just going to have to be more careful in the future and toss this one out?

Thanks in advance.

Stop by your favorite pharmacist and ask for some 3ml BD Brand syringe's. They'll usually give you a hand full of them for a buck (or sometimes even free).

Use a dremmil disk or box cutter to cut the needle end off the syringe. The numbers will rub off of the syringe with your thumb if they bother you. Now you have a replacement sleeve that won't crack and can deal with any juice you throw at it.