Cloud chasing

[Inception]

So I have just a simple mech mod I picked up from a local vape shop ( included photos) but I think it can be preforming about 100 times better. I'm just wondering what can I do to get the biggest clouds out of this device.

that's what it looks like

this is the only air hole on this rda. About 1mm

currently running a dual macro/micro coil

Rda all taken apart.

and this is the battery I am using. What improvements can I make to this to get the best clouds?

Also I'm using a 5050 pgvg liquid

 

[Susan~S]

A few questions for you:

1. What is the ohm of your build?
2. What is the amp rating of your battery?
3. Is that a 1500mah MNKE?

Things you could do:

1. Drill out the air hole on your atty.
2. Switch to 100% VG (and be prepared to lower your nic level)

 

[Equilibrium]

+1 for what Susan said... AND.... That's the only air hole on the cap??

If so... it's only setup for single coils. You need a second hole for the other coil..

For more vapor you need more air. I would try drilling another hole in the cap for the second coil and if that doesn't work for you, try drilling both holes larger ~ 5/64" and go from there. Start small and get larger. You can always go bigger but you can't go smaller.

 

[Equilibrium]

And... the other thing I see is your coils aren't identical. The coils MUST be identical - same size and same wraps and fire at the same time AND receive the same amount of air for everything to work correctly.

 

[Inception]

It's a .8ohm build and yea I will drill out the air holes and it is a 1500mah. I changed it to just the macro and will make another macro coil. And it said it was a dual coil but Idk I'm still new to this. And will try to get vg liquid.

 

[Susan~S]

I would build a single 0.8 ohm coil and only drill out the 1 hole you already have. See how that goes (and how it vapes) before attempting to drill another air hole. Stainless is is very hard metal (very hard to drill), so do it in steps and at a low speed. Look on youtube for tips (and tools) to do it right.