Is that even a millimeter between the corners of the outer coils and the top cap?
- Status
I'm sure Skunk knows what he's doing and coils are not touching the barrel.
It fit but only with the challenge cap which has standard side airflow. The airflow channels on the stock cap stick too far into the chamber for it to fit. I used the Butcher Challenge Cap which has massive Airfliw and a tall delrin DT to keep it cool. I managed a 1.5 second pull off of it and that's it. Insane Clouds at 130W and .11 ohms
There was about a mm between the coils and also to the cap.
What are claptons really but 1-6 cores and a wrap? One man's caterpillar is another man's fused clapton. Chinese companies can get pretty creative with names for their coils
Last edited:
Ok, I gotta ask, can that support a wick that won't run dry in the middle? And if so, how?
Why so series?
Chinese companies can get pretty creative with names for their coils
Yeah, and geekvape caterpillar wire is square profile, not rectangular, sooo....
Just under .4, so a little rowdy but not singe your eyebrows rowdy. And yeah, those are for a new stack mod I have arriving this weekend. I'm running them on my Unicorn MDX stack for now.
I usually just paint my coils when I run series setups. Also, I prefer RDAs with deep juice wells. Dripping more often is just part of the deal with a series setup.
Perfect! Nice job.Just under .4, so a little rowdy but not singe your eyebrows rowdy. And yeah, those are for a new stack mod I have arriving this weekend. I'm running them on my Unicorn MDX stack for now.
So you really do have no clue even with an example in your hand.
It's an old one I've posted many times, but I love how over the top it was.
I love this build, and I"m still amazed you were able to vape it for 1.5 seconds
- Status
