Completly new to vaping but have a bunch of stuff i dont know how to use.

Status
Not open for further replies.

aycue1

Full Member
Aug 22, 2013
6
1
780
So i have tried using the Blus to quit smoking for a long time. It didnt work, so my cousins friend did recommend i try upgrading to mods etc. Basically my cousins friend bought me a bunch of stuff and told me to call him if i have any problems. The problem is my cousins friend is currently working over seas and has no contact with me. So i am completly new and have n o idea what to do. So would it be possible if you guys linked some videos or even try and tell me how to put this thing together/set it up. I have done alot of research and came to a conclusion that if i do somehow put this thing together wrong there can be serious consequences so i am quite scared of putting something wrong in and screwing it up all together. The stuff i currently have:


jolly rancher lush


804 efest bio charger v2


747 efest 18650 flat top 2000mah


nimbus drip atomizer


silica wick


k100 mod


kanthal wire.


Any kind of help is greatly appreciated. Thanks guys!
 

Margate69

Super Member
ECF Veteran
Verified Member
I think some of this is a little out of your league at the moment. You have a rebuildable atomizer and they are complicated. I hope someone can recommend a good clearomizer for you to start on. At least until you learn a bit more about your device. Otherwise from what I see the K 100 is a great mod and you should be really happy with it.
 

Choc_Addic

Super Member
ECF Veteran
Verified Member
Jun 26, 2013
949
447
Caldicote tunnel
Do yourself a favor and pick up the following kit as a starter.
1. Evod kit.
2. EVOD Electronic Cigarettes Atomizer Heating Core (5-Pack).
3. what ever juice you like.

That should keep you happy while you learn about the vaping. The stuff that you have are for advance user. So before that battery (non protected + mech mod) blows in your hands, learn and read about them.

Good luck.
 

fatb0y

Full Member
Verified Member
Jul 27, 2013
29
13
United States
I would say just buy this if you want to actually try the stuff your cousin's friend got you.

Rebuildable Atomizer Coils - Avid Vaper I would recommend the 1.5 or 2.0ohm for your first time.

Your atomizer is made to run 2 coils, but it will also work with just one coil. if you look at the coils I linked you, you would put one end of the metal wire under the center post and the other end of the metal wire would go under one of the off-center screws. If you want to use 2 coils, then the second coil would also have one wire through the center, but the other end would go under the unused screw.

Once you have the coils screwed down, make sure that the metal coil isn't touching the bottom of the atomizer, if it is just nudge it upwards a little until its elevated slightly. Stick your atomizer on your K100, and tap the fire button for like a second and see if any of the wires aren't lighting up. if some aren't lighting up, nudge at the wires a little bit and try it again, once your wires all light up evenly, you can cut off the excess wick and wire and drip some juice on your wicks and fire it to check everything is still working smoothly. If everything is running smoothly, the just throw your top cap on and give it a vape. Although I don't know how fast the coil is going to run dry at those resistances, I do know that dripping atomizers are a pain in the ... because you have to keep dripping them and they run dry after a few hits and if you vape a dry hit, you're gonna have a bad time.
 

docp1620

Senior Member
ECF Veteran
Aug 14, 2013
76
21
McHenry, Il. United States
I'll repeat what has already been said, a nice setup but not what you need now. there is a bit of a learning curve with rebuildables. If you want to use this set up I agree with fatb0y in that you should pick up some coils from Avid Vaper. Otherwise might want to look at something like an ego-c twist with some type of tank system like a t-3 or protank, iclear 16 or 30, along with several small bottles of different flavors of juice. If there is a brick and mortar store in your area they can help you with a set up that might work for you now until you get more experience and can really use the set up you were given.. Good luck with what ever you decided
 

ghola1was

Ultra Member
ECF Veteran
Verified Member
Jul 20, 2013
1,724
5,703
NV USA
Take heed of the advice given. Happy to have read that you are feeling cautious.

Don't feel like all that stuff you've got will be wasted. Get yourself a ProTank or Evod, learn to recoil it. Find a multi-meter, it will be your friend.

Just take it slow, enjoy the vape and don't worry too much. I got a feeling you'll catch on fast.
 

Worzel

Super Member
ECF Veteran
Jan 3, 2013
870
804
Lakeland, Florida
Sounds like you have an interesting list of things going on there. Do you have kanthal wire for the wick? For the K100, all you really need are some Boge or Smoktech (not punched) cartos to drip the juice into and you should be good. Your K100 came with cartos? The cartos that come with the kit suck, but are do-able. Try that out for a while.


Sent from my .... in your general direction.
 

ClairzyDoats

Full Member
Verified Member
Aug 22, 2013
39
15
Fairfield, CT, USA
Stop! Back away from the stuff. It's waaaaay too advanced. Here's a basic starter. Go to myfreedomsmokes.com. Find the eGo 650 mAh w/CE4 Clearomizer Blister Pack Starter Kit. It's $14.95. Get 2. Get a bottle or two of juice. THIS will get you started and you even get a (basic) variable voltage battery that you can experiment a bit with. I just got this for a friend who was using Blu and South Beach Smokes and he's in heaven.
 
Status
Not open for further replies.

Users who are viewing this thread