ive taken out the 510 and placed it back in, ive put 3 new coils in, made sure they was tighten'd down as much as possible, ive completely took apart the deck and re fitted it, cant think of what else there is too do, I'm using the smok alien I don't have any other mods.... hmmmm it cant be the atty as its brand new,
constant "NO COIL" "OHMS TOO LOW" reading, what are the fixes?
- Thread starter Ragnar94
- Start date
- th_trl_thread_readers 0
- Status
Sounds like you might have a short on the build...Is this the 'Cane v2 perchance??
yeah what ive noticed is though, the deck becomes slightly wobbly when I screw it in to the alien :s
I reckon its the 510 pin... spent 5 hours so far on this atty haha what a piss take!, all be worth it in the end though
Konstantinos Kazantzoglou
Full Member
It could be the Peak insulator on the posts, do you have another atty to test the mod in order to eliminate the chance of a problem from that end?
ill take the deck apart once more I guess..... try another deck as you get three different ones... and only one of them comes with a peek insulator
Konstantinos Kazantzoglou
Full Member
It happened to me on a Lost Vape Triade and a Goon 24 with a low built and batteries @20% on power mode but it was resolved with a fresh set of batteries, if you have an ohm meter try to see of you get a reading of the built.
ive also just noticed there is O RINGS holding the first deck in place..... ill push it in as far as possible....
theres a point my batterys are dead almost... I do have a UD ohms metre but I could never get it working? numbers always stayed the same.... ill whip it out and see if I can get it going
is the deck in the right way around? If its similar to the v1's it is possible to get it in wrong although it shouldn't give a short. I was going to suggest the PEEK insulator also!
there should be an insulator on the postive post that you can detach to change the AF I think (i am guessing here a bit as i dont have one......yet....)
the deck instantly started wobbling when I put it on the ohms reader, perhaps theres something wrong with the 510? :S....... it has 3 o rings attached? maybe they're not in the right places....
i think the o-rings are fine but the 510 isnt screwing into the deck base properly...
right well I guess that's whats happening then, just screwed it on to the ohms metre, the deck instantly became loose as anything, unscrewed it went back to solid as if itd been glued on..... surely I'm not the only one with this issue :s better contact e phoenix....You need a nice (German) 23mm tube mod for that beast mate
- Status
