Thought id ask while this post is up, am i being daft or is there a way to dual coil this ? http://m.imgur.com/GSPtI3W
constant "NO COIL" "OHMS TOO LOW" reading, what are the fixes?
- Thread starter Ragnar94
- Start date
- th_trl_thread_readers 0
- Status
If anybody could help, itd be greatly appreciated, the instructions dont make it clear and e phoenix just arent there to help,
http://m.imgur.com/9Ikxb5y,NvQpcX6 Aint got a clue which part goes where, just built it up and it flooded everywhere,
Before the velocity style deck became the standard dual and triple post designs, with one hole per post, were common. You simply install the coils on opposite sides of the posts, with the positive leads of each coil in one whole and these negative leads of both coils in the other.
Sent from my M7_PLUS using Tapatalk
Just a heads up guys, the Hurricane V2 really excels in DL, I stuck in a 22 G 8 wrap coil, wacked it up to 46 watts and it 's just phenominal, haven't tasted anything like it.... if you've had the pre built smok tfv8 coils you'll know what tasty is... I'd say its on par or better than that....
Phenominal.... very happy with this purchase, It's going to be hard to pick between the doggystyle 2k16, hurricane, and taifun gt3.
best thing about the hurricane has to be the variety in the build decks..... very simple to wick too, just cover the juice holes.... you basically get a improved hurricane V1.3, and a hurricane junior in 1..... I will not complain
was going too, then I remembered when I offloaded all my old bits, Rose 3, Kayfuns, I only had one atty, and it got quite boring, the taste is great but you get bored building on the same deck over and over,
This happened to me last night. I found the problem.
1. You'll need to unscrew the four screws at the top of the mod.
2. You'll need to glue the part that goes flush to the mod where you screw the tank into. (510 piece I'm guessing)
3. You'll also need to have a soldering iron, what happens is that when that piece turns it actually breaks away the wire that was once attached to it.
4. Now after you glue that piece so it doesn't turn with the tank, you'll want to solder the wire to the piece that you glued on.
Everything works perfectly now, my only suggestion is don't unscrew the all the screws as its a pain in the .... to get the buttons back on the mod. Hope this helps anyone who is trying to find the problem!
Cheers!
Last edited:
- Status
