Well I just hated the Lady 801 Atomizer, and felt that it needed more of a kick. So I took a Auto Battery, and then cut the guts out top down. I desoldered all the connections to the smart chip from the battery, and then more or less just had a 510 female plug hooked up to a smart chip.
The Micro Pipe was a little hard to strip, and I think there was a better way at the way I went at it. I took chain locks and twisted it till the plastic ring around snapped. Then I slowly pulled the plastic out, before pulling the lady smart chip out, and cutting the lines. Then I soldered on the new smart chip to the old wires in the lady pipe, and because I am out of heat shrink tubing used hot glue to seal the wires up. Then I pushed the new setup inside the Lady pipe and then a taste pull smiling because I know that it worked. I then took one of the rubber tips for the Lady Pipe, and then slipped it onto the back in of the 510 cart.
Throat kick has improved, and also vapor production improved from what it was before.
I want to call this the Lady 510 Pipe
The Micro Pipe was a little hard to strip, and I think there was a better way at the way I went at it. I took chain locks and twisted it till the plastic ring around snapped. Then I slowly pulled the plastic out, before pulling the lady smart chip out, and cutting the lines. Then I soldered on the new smart chip to the old wires in the lady pipe, and because I am out of heat shrink tubing used hot glue to seal the wires up. Then I pushed the new setup inside the Lady pipe and then a taste pull smiling because I know that it worked. I then took one of the rubber tips for the Lady Pipe, and then slipped it onto the back in of the 510 cart.
Throat kick has improved, and also vapor production improved from what it was before.
I want to call this the Lady 510 Pipe





Last edited: