Cotton rebuild ? Getting cotton particles in your throat.

Status
Not open for further replies.
Hello all after doing a few Kanger coil rebuilds really enjoyed the taste from my cotton wicks, However noticed after a while I would get a cotton particle stuck in the back of my throat.
I don't know how to avoid this. Using organic cotton boiled for 30 minutes.

Any suggestions would be great. Using Protank 2 with evod coils rebuilt with cotton and 32g Kan.

That cotton particle is a pain to get out of the back of your throat.

Don't want to go back to silica tastes is nothing compared to cotton.
 

JasonV

Full Member
Feb 23, 2014
16
8
DFW Tx
Do you need to boil your cotton because you prefer the taste or because that is what you were always told? Boiling is not necessary unless you experienced flavor change that many people say they tasted without boiling. (If you do need to boil, 3 minutes is all it takes to sterilize. 30 minutes is just making yourself wait an extra 27 minutes). It may be the brand of cotton you are using. Are you cleaning out the tank after you remove the old coil or are you just switching it out?
 

flbutterfly1

Ultra Member
ECF Veteran
Jun 16, 2010
1,171
266
Interlachen, Florida
I use cotton balls too and on my rba so the wick is right there under my drip tip and no cotton in my throat. I have even made a very long wick that goes under my drip tip and into my tank still no cotton in my mouth. If you are using a high vg liquid it can leave a deposit in the back of your throat that feels like something stuck and you want to cough a lot. But other than that nothing else has ever stuck in my throat.
 

CHEAPERS

Full Member
Feb 6, 2014
48
56
northeast
You might be getting what I call small fireworks. In the factory set-up, I don't believe the "Flavor wicks" are for flavor at all. They are Firework control. Try a very (very) small flavor wick of cotton on top of the main wick. It will give you a tighter draw but controls the fireworks. If You start making your own coils, go vertical. Good Luck.
 
Status
Not open for further replies.

Users who are viewing this thread