Could you?

[ballallday]

Could you use the Tugboat rda clone v1 in single coil mode? even though there are two air holes. Does it matter?

 

[Susan~S]

I have heard of members blocking off the 2nd hole when building single coils. I don't remember what material they were using.

 

[Hppsc]

What Susan said, "Block it up." Materials used for vapers are usually what ever you think of 1st that's on hand. If you really like the setup, then think about what material will holdup & not look like you rigged it w/ duct-tape & bubble gum. (Stoner rigged)

My 1st thought is to put a little juice on cotton/rayon, twist into a point, feed through the hole/ holes until tightly clogged & then trim the outside off.

It's riggy as hell, but WTH. Am I right, or am I right?

A quick BTW: I'm always right. I'm a woman. ;p

 

[oldbikeguy]

A hole puncher and some electric tape make a nice little round temporary patch for a more permanent job a small dab of epoxy works

 

[ballallday]

Lol but do you have to cover the second hole? I mean what would happen if you didnt?

 

[SP3C1ALSAWC3]

If I build a single coil on my plume veil, I sometimes leave both air holes open. Only makes for an airy-er vape

 

[eyerhere]

Oh he// if you vape a single coil through dual air holes you could knock the planets out of alighnment causing chaos bringing the civalized world to an end.
Wouldnt scotch tape be easier?

 

[Kenna]

Gorilla tape.

 

[Hppsc]

The tape would melt. If you're cool w/ vaping melting plastic, then gittyup!

 

[rodeo302]

Try it with them both open who knows you might like it if you dint I've never had a problem with taping over the hole.