Cyclone non-afc air hole

[Joe A]

I have both versions of the cyclone, but I'm still finding the draw on the non-afc real tight even drilled with a #54 bit. I pulled the coil closer to the posts but with minor improvement. Thinking of going to 1/16", any opinions?

Sent from my LG-V510 using Tapatalk

 

[supertrunker]

A lot of RM2 users drill them to 1/16", stock is 3/64 if i recall.

You'd do well to look for posts by Super X Drifter who is something of a legend at setting these things up.

T

 

[Paul.K]

I have the non-afc cyclone drilled out to 1/16" and it's pretty good for me. How big are your coils?

 

[Filthy-Beast]

since you have the AFC how far open on that do you like? I wiggled a 1/16 around so it larger than that but not yet a 5/64.

 

[super_X_drifter]

Joe, have you tried positioning your coil like my picture above? Well off the posts.

Also running it about 1mm off the deck.

Additionally, if the wick gets sucked up and pointing skyward it'll affect the vape / tighten it up.

I find (in all situations) that very short tails on your wick are where it's at. Long tails just lame up the vape.

 

[Joe A]

I move the AFC multiple times per squonk. I'm odd like that. SXD I haven't pulled it that far out yet. I guess I'll give that build a try.

I'm currently running 7 to 8 wraps of 28 gauge around a #54 bit. Sometimes I'll go 7 wraps around a 1/16. I had both of my RM2 opened to 1/16 but didn't want to drill the cyclone to quickly. Its cheap and easy to get an RM2 cap, not so much for a cyclone. That why I went with the 54 bit to start off.

I'll try SXD build and then jump up to 1/16 if I'm not satisfied with it.

Sent from my LG-V510 using Tapatalk