dead atty?

Status
Not open for further replies.

DillPickle

Full Member
Verified Member
Dec 15, 2010
23
0
Honolulu, HI
Picked up a Riva 510 from LF about a month ago, and have been using the regular atty that came supplied. This morning I swapped the atty onto a newly charged battery and found that whenever I push on the button, it blinks like it would if it were a discharged battery. Just confirming... does this mean that the atty is dead? If so, is this the only clue as to knowing that it's dead, aside from testing the resistance?

How long do they normally last? I'm not a heavy vaper as the Riva can last me from 2-3 days at a time.
 

Jessara

Super Member
ECF Veteran
Dec 18, 2010
360
1
SW Oklahoma
That happened to us as well. But it wasn't the atty - the recharger had malfunctioned. We thought the batteries were recharging, but they weren't. We contacted the vendor we got our starter kit from (only 9 days earlier), told him what was happening, and he sent us a replacement free of charge. Soon as we got the new recharger, all was well again.
 

WomanOfHeart

Vaping Master
ECF Veteran
Sep 19, 2010
5,430
1,253
60
Colorado
That does not mean the atty is dead. There's probably something wrong with the battery or your charger. The light on the Riva/eGo batts only deals with the battery. I would try the atty on another battery. I bet it will fire. Then check the charger by plugging it in somewhere else and see if it's actually charging.
 

dormouse

ECF Guru
ECF Veteran
Oct 31, 2010
12,347
1,611
Pennsylvania
Surprisingly I actually did hear of that happening to someone and for him it was a gunked up atty and it started working right after he cleaned the atty. Have you been cleaning your atty? I swap attys and clean the used one every weekend. I put the dirty atty in jar of vodka or grain alcohol overnight. make sure the air is out of it and swish it around. Next day I shake/blow it out and and set to dry on paper towels (or you could blow through it a lot of use a hair dryer). There are quicker ways to clean attys with boiling water but I've never done that and water takes longer to dry.

But it could also be your battery, your charging cable or your AC to USB adapter.
 

DillPickle

Full Member
Verified Member
Dec 15, 2010
23
0
Honolulu, HI
Have two batteries, that the charger indicates as being fully charged. Have said atty and a brand new atty. New atty works fine on both batts and the suspect atty will cause both batts to blink. I've been cleaning them every 5 days or so... hot water soak, blow out, wash, rinse, repeat...

Any other ideas? Will contact the vendor to see what they have to say.
 

JonnyVapΣ

Ultra Member
ECF Veteran
Verified Member
Sep 23, 2010
1,778
177
49
Rochester NY
Looks like that atomizer is bad. No biggie. That's the "consumable" part anyway. They don't last forever.



Edit: Another possibility is that the center connector on the atomizer has gotten pressed in too far and not allowing a good connection. It's rare but does happen. Try carefully prying it out a bit. By "a bit" I mean...about the thickness of a couple business cards. The coil wire is soldered to this connection and will break easily especially after being used a while.


At any rate, a multimeter would tell you for sure.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread