DID Clone, have a question

[Thomas Simms]

I have some DID clones coming in from coops and i was wondering if anyone has something like schematics, blueprint, dimensions. Something that i could use for accurate measurements. I have some modding planned for one of these but i want to do it right with all the dimensions so it doesn't look thrown together. I might just have to contact the supplier to get this but its worth a try. Thanks everyone!

 

[Nurzrachit]

You may want to ask in the DUD build thread too. There are several members who already have theirs up and running.

 

[spraintz]

Thomas, I will be breaking mine down soon and and will get the calipers on all the pieces and post the measurements in the DuD build thread, any specifics you need?

I kinda feel bad taking it apart since it works so well but dangit.....I gotta make me a clear tank...

 

[Thomas Simms]

I was going to be looking at the hole sizes in the top cap for sizes and spacing. Im going to be drilling some more holes in the top for possibly dual coil setup. Ill also be looking at your measurements for a clear tank.

Also where is the build thread?

 

[munchichee]

I was going to be looking at the hole sizes in the top cap for sizes and spacing. Im going to be drilling some more holes in the top for possibly dual coil setup. Ill also be looking at your measurements for a clear tank.

Also where is the build thread?

Size:55(L)mm*16(D)mm(not including drip tip).

Tube Size:25(L)mm*16(D)mm.

Airhole size:1mm.

Capacity: 3ml e-liquid.
Thread: 510/eGo

not sure about wick hole size or spacing. I don't have the tools to measure but I'm sure someone does.

http://www.e-cigarette-forum.com/forum/rebuildable-atomizer-systems/334958-dud-builds-2.html

 

[Thomas Simms]

Size:55(L)mm*16(D)mm(not including drip tip).

Tube Size:25(L)mm*16(D)mm.

Airhole size:1mm.

Capacity: 3ml e-liquid.
Thread: 510/eGo

not sure about wick hole size or spacing. I don't have the tools to measure but I'm sure someone does.

http://www.e-cigarette-forum.com/forum/rebuildable-atomizer-systems/334958-dud-builds-2.html

Do you know if the tube dimensions are ID or OD?