Did I break a 510 connector?

[_p_a_n_d_a]

Hey guys this post officially breaks my forum virginity.

Well I was trying to make a box mod and I needed a 510 connector so I thought "maybe just take it off my old ego." I took it apart and threw away the excess stuff. Turns out, the excess stuff, were some wires and things I needed. I read on some posts after that you needed the wires that connected to the positive and ground and stuff, but all I have is the connector and underneath is a rubber insulator with a blob of solder on it.

Can I solder another wire on that blob or what else can I do?

I'm also looking at buying an alternative to the 510 because I don't like waiting too much for shipping for online. Stuff like RCA connectors and E-10 Bayonet Bases. Pics up soon.

 

[Nataani]

You could always try, just check the conductivity across the connector afterwards. IMO, better not to though.

 

[Nikkel]

http://www.vaporgrounds.com/category/tutorials/
How to solder a 510

 

[Bunnykiller]

yup use the existing solder points to reattach the new wire to, be sure to get the proper wire thickness if you are going non regulated...

 

[_p_a_n_d_a]

Thanks guys it really helped!