Direct drip on 510 atty?

[smithdl]

Hey guys i just got my 510 in the mail, and had a question about direct dripping for it. I used to have the Blu, and the atty on that is not covered by a black tube, so it was easy to see when i am dripping onto it.

Is there any specific technique or video that shows how to direct drip on the 510 atty properly? I tried to direct drip on it but it appears to be flooded because i am not getting great vapor, and it is making a gurgling sound when the battery is activated.

Thanks for your help Vets! =]

 

[Kent C]

Hey guys i just got my 510 in the mail, and had a question about direct dripping for it. I used to have the Blu, and the atty on that is not covered by a black tube, so it was easy to see when i am dripping onto it.

Is there any specific technique or video that shows how to direct drip on the 510 atty properly? I tried to direct drip on it but it appears to be flooded because i am not getting great vapor, and it is making a gurgling sound when the battery is activated.

Thanks for your help Vets! =]

Yep. Sounds flooded. Blow out from the threaded end into a paper towel. That should clear the flood. Then never drip more than 3 drops on a regular ohm'ed 510 atomizer. If you're going to drip also best to get a drip tip - many vendors have them. Basically you can drip directly on the metal mesh of the atomizer bridge that sits above the coil. Joye 510 atomizers also have metal mesh around the base of the bridge which helps hold the ejuice better than the SLB (washer) types where there is a washer at the base.