Disappointed in CE2? Try this!
- Thread starter CloudBurst
- Start date
- th_trl_thread_readers 0
- Status
storm...maybe you missed my question but how are you drip filling down the sides with a filler ring in place?
Nice stuff Stormi! I don't get how this changes the burnt taste problem though, is the coil kept wetter? One observation just from the photos, when using the tube cutter it flares the thin SS tube edge inwards, and during the initial fitting of the syringe tube most likely expands some, so there ought to be some room for play with differing syringes. A bit of heat should help too.
I think it gives it more room to wick rather than be smashed up against the ceramic cup. I think the plastic is somewhat forgiving when you slide it on also.
ok so the juice basically stays unsuspended in that reservoir with no filler? this has to be awesome. is there a special material used as the wick? im wondering, because if that wick and those wires can be lengthened, theres potential to be able to add even more space to that reservoir, right?
Oh ya, folks are making bottle mods with them too. Anywhere from 3ml to 15ml if memory serves me ....
I don't have the right bottle dia, or i might try one of them too. It all seems so similar to stock, but the difference in wicking and flavor is night and day. Trust me the syringe mod is a FREAKIN GREAT VAPE!
I made mine with the BD 3ml and its tight. I had to boil the plastic tube and put the metal carto in the freezer. Then it pushed on HARD. I don't plan on taking it back off ever
Never leaks out the bottom though. I don't need to travel with mine, its just a home unit. A regular with cut wicks and PTB is my travel set-up.My camera doesn't do close ups too well but I cut it about the same size as the gap in the ceramic cup. I can't believe how good mine are vaping right now! The rinse and dry burn after each fill up is the key to great taste and lots of vapor!
Before I go looking does anyone have a good linky to purchase the syringe for the mod? I used my only syringe from mad vapes which was a B-D. I heard the Terumo (sp?) brand was a bit softer and from what I understand a slightly larger ID.
I really hesitate to go into a pharmacy to ask about these and have to explain why I am wanting them, etc., as it doesn't appear that you can buy these off a shelf?
I really hesitate to go into a pharmacy to ask about these and have to explain why I am wanting them, etc., as it doesn't appear that you can buy these off a shelf?
In your experience using the Terumo or monject's is the filler ring seating back in there properly? I am going to look on the net and try to find these for purchase...
Yes, the filler ring seats fine. Be sure to do this or any work w/ it threaded on a batt. I like to use an old one for work.
Ebay and I find the filler rings to work fine on both kinds.
You could look at the feed store, they keep them on the shelves.
Sent from my Droid
You could look at the feed store, they keep them on the shelves.
Sent from my Droid
i made one too. vaping on it now. it was piece of cake making it. thanks again storminyte
crappy picture attatched
crappy picture attatched
Last edited:
i like it a lot. its cool being able to see the juice level going down. it took me less than 5 minutes to make it!! who needs suckAton or juice feeder? THIS is the juice feeder!!
I think one of the best aspects of it is you can see where you are with juice...did you place the filler seal back around it?
- Status
Similar threads
