DNA200 chip, Boxer mod

[Hugh Betcha]

Hi all,

I recently purchased the Boxer 133W, DNA200 mod.
I have noticed when I set it to 30w or any wattage for that matter and push the fire button it always goes down to zero, then back up to 19 or 20 and then to my desired wattage.
Is this normal or is there something wrong with the chip?

I also noticed, when I scroll from top to bottom on wattage mode it will speed up/slow down/ and speed up again. Again, is this normal?

Many thanks

 

[daviedog]

Hi all,

I recently purchased the Boxer 133W, DNA200 mod.
I have noticed when I set it to 30w or any wattage for that matter and push the fire button it always goes down to zero, then back up to 19 or 20 and then to my desired wattage.
Is this normal or is there something wrong with the chip?

I also noticed, when I scroll from top to bottom on wattage mode it will speed up/slow down/ and speed up again. Again, is this normal?

Many thanks

I have hcigar vt 133,, dna200 with 2/18650. Mine does not do that.
Did you do escribe?

 

[Hugh Betcha]

I have hcigar vt 133,, dna200 with 2/18650. Mine does not do that.
Did you do escribe?

No, no escribe. Am on Mac computer.
Thanks for the quick reply.

 

[dcfluegel]

yah - sounds like default settings manufacturer may have loaded on mod - can be adjusted with escribe pretty easily

 

[kbeam418]

Mine does something similar, as long as it vapes fine I wouldn't worry about it. Evolv boards show EVERYTHING in real time including voltage, watts, battery voltage, even resistance!

 

[mindriot]

No, no escribe. Am on Mac computer.
Thanks for the quick reply.

If you happen to have a windows install disk kicking around perhaps from a previous computer or the likes then escribe does work fine when used with Bootcamp, VMWare Fusion, Virtual Box and I'd imagine Parallels also. It is a little bit of an annoyance compared to install and go, but if you are keen to adjust some things on your mod then those options do work.