So I built an Nes controller mod, got it charged and went to flip the screen because it was upside down. put it into locked mode, then held fire and down, no difference, then fire and up... still upside down. and it was flickering, so i sent it in and the folks at evolv sent me a new one, so this time instead of wasting my time soldering a million wires I soldered + and - on and hooked it up to a battery and tried using the on board buttons, same thing, screen wont flip, read the evolv instructions.... again.... and I'm reasonably certain I'm not doing anything wrong, the screen is indicating that it is switching between right and left mode.... but nothing actually happens... so is this just a second faulty one or am I the issue? anyone with a similar experience?
