Do you think a DNA 40 chip would fit in an SVD 2 Tube?

[Deadcenter]

This 20w device is so 3 months ago and just doesn't cut it anymore and I've moved on. It is well built and but for the board could last years.
Since Evolv made the board, I wonder if it's the same size as their other chipsets. ???

 

[ayopassthat]

Time to break out the calipers and data sheets

 

[chefjoosie]

Hard to say since it's a custom board rather than an off the shelf DNA20. If it's the same size as a DNA20 it'll fit. You'll just have to snap off the mounting rails from the DNA40 and it'll be the same size as the 20.

 

[Phone Guy]

If I had to guess, no. I remember watching the pbusardo video, and innokin wanted that board made to their specifications... but I think the only answer here is "maybe" - you won't know for sure until you try. I hate making a reply like that, but that's kind of a special mod. It would make a great project though! If you do it, take lots of pictures for us!

 

[xtwosm0kesx]

I feel like there's a decent chance Evolv would answer this question if u contacted them, assume there's no reason they couldn't give ya the dimensions of the chip.

 

[Phone Guy]

I doubt Evolv will answer that, but again - MAYBE. I explained to them I had a failing DNA20 chip from another device (Futura mod) to see if there was anyway to get it repaired or warrantied - they told me to contact the vendor of the mod, after they sell the board to them, it is no longer possible for them to interact with the customer... Maybe I caught someone on a Friday at 5pm ? I DUNNO....

 

[jmarkus]

dimensions are on page 9:
http://www.evolvapor.com/datasheet/dna40.pdf

 

[Phone Guy]

I thought we were talking about the specs for the innokin DNA board inside the svd2

 

[ayopassthat]

http://www.evolvapor.com/datasheet/dna40.pdf

The datasheet tells me the board is .65 inches wide without the mounting rails. An 18650 battery (which goes inside the SVD 2) is .7 inches. Assuming the inner diameter of the tube is consistent, yes the DNA would fit. It's gonna be tight but it's worth a shot

 

[KTMRider]

http://www.evolvapor.com/datasheet/dna40.pdf

The datasheet tells me the board is .65 inches wide without the mounting rails. An 18650 battery (which goes inside the SVD 2) is .7 inches. Assuming the inner diameter of the tube is consistent, yes the DNA would fit. It's gonna be tight but it's worth a shot

The rails on the DNA40 board is scored so it's easy to snap off.