Does anyone use a dna 20, provari or VV with their rebuildable?

[suspectK]

I think the ProVari is picky, yes, but it's a good kind of picky if that makes sense. I build my Genesis attys at about 1.0-1.2 ohms (which is the lowest ProVari will take) and sometimes it'll vape fine and then I'll pick it up in 5 minutes and get E1 errors. I don't get that from anything else I throw on top.

I don't understand.. are you sure you're not getting a short? I don't know if you're using any other regulated gear, but that doesn't make any sense.

 

[Credo]

I actually prefer doing my RBA and RBT builds on regulated/boosted batteries.

I don't need unregulated mods unless I do builds with more than 2 coils (or twisted stuff). A rare treat since I can't afford to keep such an atty juiced on a daily basis.

 

[BDUAres]

I use a Rocket RBA or a Fogger V2 on my Provari as my daily vape. Run them on the Vamo as well. I have had the Provari running fine at 1 ohm easily, but I tend to use 1.3-1.8 ohms regularly.

 

[t8kiteasy]

I run my R91%,Terminator-C,Immortalizer,Helios,on my Lava tube 2.0 later in the day with 30AWG at 1.2-1.5~.Early morning I generally build them with a .5~ coil on my Precise ELA.I prefer sub ohming on my mech's vs. Regulated though.

 

[Dj Xy]

I always use RDAs wrapped at 1.5-2.0 ohms of 30 gauge on my Vamos for tasting my diy mixes, it allows me to see what wattage a mix tastes best at, then I wrap coils for my tanks accordingly.
So as long as you wrap your coils in the proper ohm range for your device, it wont matter if you use it on a fixed voltage, a mech, or a VV/VW device.

 

[mavric]

I don't understand.. are you sure you're not getting a short? I don't know if you're using any other regulated gear, but that doesn't make any sense.

Yeah. I know what's happening though. The coils I've been aiming for lately have been right on at 1 ohm. I think when I fire the mod it drops the resistance just a tiny bit, enough for it to fuss. You can hear the coils start to vaporize then it cuts out. I confirmed this by checking the resistance with the actual mod (it fires it to monitor any changes) and it does drop to .9. I just need to wrap them a little higher, but 1 seems to be my sweet spot on them, so if I feel like using one I'll just throw it on a mech.

 

[suspectK]

Ok. That makes sense. I didn't know if you meant it did that at 1.2ohms as well.

I need to break my genesis out. I don't think I've played with mesh since discovering micros...

I don't think I answered the OP... I don't own a non-buck/boost pv.