Coppervape Skyline Styled RTA JUICE FLOW CROSS THREADED?!?!?
^ yes, not removing the o rings were making it even harder to use the juice flow control.
But I just discovered my clone skyline juice flow doesn't fully close. Maybe a defective batch? maybe the particular clone? I checked youtube videos of authentic and no one addresses this or shows that much detail of the juice control but by the looks of it the genuine one might also not fully close off.
The chimney part that lowers actually contacts the top of the deck post before it can fully close. It hits the top of the grub screw. If I remove grub screw (as if my fused clapton is too thick for what they had in mind for wire gauge for this MTL tank) then it still hits the post without wire or a grub screw. It's a good 32nd - 16th inch space I can see the cotton clearly.
I haven't used this tank in years and tried it last night. Had problems with a 316L SS fused clapton being detected for Replay mode on DNA250C. It WAS showing "SAVE PUFF?" at first but then stopped giving the option,, that's a different (and almost common) problem I have to look into but I don't think I'm even keeping this tank. I must have juice flow control.
it wasn't leaking or gurgling too much or really at all. Set it down overnight with 1/3 tank and it all leaked out. I need Juice flow for if keep tank in hot car or something and juice gets thin, etc there are scenarios where I feel juice flow is a must, so anyway, can yous with either genuines or clones confirm also that the juice flow doesn't even FULLY close?
^ yes, not removing the o rings were making it even harder to use the juice flow control.
But I just discovered my clone skyline juice flow doesn't fully close. Maybe a defective batch? maybe the particular clone? I checked youtube videos of authentic and no one addresses this or shows that much detail of the juice control but by the looks of it the genuine one might also not fully close off.
The chimney part that lowers actually contacts the top of the deck post before it can fully close. It hits the top of the grub screw. If I remove grub screw (as if my fused clapton is too thick for what they had in mind for wire gauge for this MTL tank) then it still hits the post without wire or a grub screw. It's a good 32nd - 16th inch space I can see the cotton clearly.
I haven't used this tank in years and tried it last night. Had problems with a 316L SS fused clapton being detected for Replay mode on DNA250C. It WAS showing "SAVE PUFF?" at first but then stopped giving the option,, that's a different (and almost common) problem I have to look into but I don't think I'm even keeping this tank. I must have juice flow control.
it wasn't leaking or gurgling too much or really at all. Set it down overnight with 1/3 tank and it all leaked out. I need Juice flow for if keep tank in hot car or something and juice gets thin, etc there are scenarios where I feel juice flow is a must, so anyway, can yous with either genuines or clones confirm also that the juice flow doesn't even FULLY close?