Double Barrel Micro Coil w/ 28g in a Kayfun

[Despraci]

I'm sure a lot have seen the 30g nano coil build, but I wanted something that had more surface area. So I used 9 wrap 28g that I used for my regular builds and decided to see if I could shove it all inside the chimney of a Kayfun.

Results was .6ohm double 9 wrap Micro coil w 28g

I used a clone Kayfun base that had deeper juice wells to try and reduce dry hits.
A Kayfun nano chimney will not fit on this build, but the stock chimneys do.

Why? Mostly I was bored.
How's it vape? No idea, I am waiting on my mod to get here that could actually fire the thing up.

Excuse the couple coils out of place, since I can fire the coils up, I can't squeeze it together anymore then what it already is.

This is what happens when you have an tank laying around and some extra kanthal.

 

[ngc604]

I liked the double barrel coil setup. I set mine up with the opening pointed toward the screw heads and out of one solid piece of kanthal. I believe mine was at .8 ohm. Used that for a few months but it used too much eliquid that I couldn't justify keeping it in. At that time I bored two half circles into the bottom chimney cylinder. The holes lined up with the juice channels. It flowed extremely well and no dry hits.

Your build looks good. Very nice.

 

[Despraci]

Thank you, and the juice usage is one of my concerns as well. I figured I'll probably go through twice as much juice roughly.