Draw tighter than normal

[FundamentalForce]

I just built a 2.0 ohm coil in my Kayfun Lite and it seems to have a much tighter/less airflow draw than lower Ohm coils. Could this be caused by it taking longer to heat, or did I just use too much cotton in my wick? I should also mention the juice doesn't have a lot of flavor, but that might be normal as I've never used this juice before. I'm a little new at rebuilding so any help would be appreciated!

 

[FundamentalForce]

Oh, and I'm vaping at 10.2 Watts on my ProVari 3 set to boost 1.

 

[Tom Fuller]

I just built a 2.0 ohm coil in my Kayfun Lite and it seems to have a much tighter/less airflow draw than lower Ohm coils. Could this be caused by it taking longer to heat, or did I just use too much cotton in my wick? I should also mention the juice doesn't have a lot of flavor, but that might be normal as I've never used this juice before. I'm a little new at rebuilding so any help would be appreciated!

Too much wick or coils that are super fat and eat up all the room in the thermo chamber tend to make it tight to puff on. Good luck.


Live Long and Vape!