Drilling out the air hole

[Kenho21]

I'm awaiting the arrival of my first rba, which will hopefully be tomorrow. From what I've seen I will be drilling out the air hole to a little larger than stock size. I have a drill bit set I will be using, but my only problem is... how in the heck do I mount a 1/16 in. bit into any drill?? That's really tiny. So, how do you guys do it?

 

[Strangebrew]

I'm awaiting the arrival of my first rba, which will hopefully be tomorrow. From what I've seen I will be drilling out the air hole to a little larger than stock size. I have a drill bit set I will be using, but my only problem is... how in the heck do I mount a 1/16 in. bit into any drill?? That's really tiny. So, how do you guys do it?

I drilled the air hole on the AGA-T (Better before drilling). If ya' have an index set of bits, start small.

So, how do you guys do it?

Hand drill...

 

[MattBott]

You can get those tiny drill bits with a larger end that will go into a a drill better. Or you can get a drill bit set for a dremel and use that.

 

[Viper8695]

You can get those tiny drill bits with a larger end that will go into a a drill better. Or you can get a drill bit set for a dremel and use that.

^^ This is what I did.

 

[lightbud404]

I drilled the air hole on the AGA-T (Better before drilling). If ya' have an index set of bits, start small.
Hand drill...

yeah, what he said ^. all I know (for sure) is 5/64 drill bit is too much for aga-t

happy vaping

 

[Kenho21]

Thanks all! I think I will go pick up a hand drill tomorrow, because I'm cheap and that sounds cheaper than a Dremel. hahaha!

 

[Trick]

I read the title and confess I was hoping this was about something else.