Dripping Question

Status
Not open for further replies.
Hello everyone,

First time posting and still trying to kick the stinkies to the curb. I've been a smoker for 25 years, 2 PAD for 10 years. Once I started vaping I cut down to less then 1 PAD. I'm proud of that but still trying to kick the rest. Anyway, great web site and I visit daily. On to my question.

I'm a few months in to my vaping journey and still a bit confused on threading and what fits what. I have a lot of juice stored up and it seems that dripping would be the easiest way to test them all. I have the Itaste VV version 3 and was thinking of getting 510 Atomizer - 1.8 ohm (with tip) it's 510 threaded and wanted to make sure it would fit my Itaste VV before ordering. Or am I totally confused and need something completely different?
 

White Rabbit

Ultra Member
ECF Veteran
Verified Member
Any suggestions for an ego twist? Thanks!

I am assuming you mean for a drip atomizer?

I just save all of my very old cartomizers. The short ones work great. Just use a straight pin or needle to probe around the filler on the outside and also around the little plastic tube inside so that the wicking material becomes loose. Then poke it out or use tweezers to carefully remove the wicking material. This leaves the center tube and the coil at the bottom of the carto. Now, just drip a few drops and vape. When finished, just blow a little water from your mouth through the carto and dry burn for a second or two, no more. You are ready to try another flavor or drip some more.

I have several dozen laying around just to test new DIY juice recipes or new liquids. Cheap, convenient, and works great.

The Wabbit
 
Status
Not open for further replies.

Users who are viewing this thread