Ok, I was targeting a dual coil .5 ohm build, something I could handle, but somehow I ended up with .4 ohms (vamo is not as precise, I guess it could go up to 0.44 and still report .4)
Took two 5/64 Drills bit
10 wraps of kanthal 26 gauge on each (I think one shows 11, I had to unwind one wrpa from one at some point)
put first one in place
second one
position and remove:
Took two 5/64 Drills bit

10 wraps of kanthal 26 gauge on each (I think one shows 11, I had to unwind one wrpa from one at some point)

put first one in place

second one

position and remove:
