E2 error when rebuilding ZAP

[Beretta]

I received an E2 error when rebuilding the coil/wick on my ZAP. (Current Limit Exceeded - Lower the voltage settings or use a higher resistance atomizer. Provari will reset when problem is corrected.)

The top and bottom sides of the coil lit up bright yellow, but the inner coil did not during this error. I kept trying, and the E2 error went away, and the coils are glowing evenly. Has anyone else experienced this? What did I do wrong? I wrapped 7 coils around the wick to give me 2.2ohms.

 

[donnah]

Don't worry about it. I get error codes all the time with my rbas. I was just giving my coil a dry burn and would get an E2.. I also got E1 and a couple E8s. The gunk quickly burned off and with a little adjusting, all my coils glowed evenly.

Just watch Zen's howto video and do what he does.

 

[Thompson]

It was possibly shorting out some where, but not so badly as to kick in E1 or LO. It had reduced the resistance but not that far.

 

[Thrasher]

D & T are correct. you just got a small short somewhere between the coils and the wick, dropping the coil resistance too low for a sec and the proV said no way man.

wierd shorts are common with genesis rba's especially during setups and te provari cant tolerate them until you work it out.