eGo XL Atty

Status
Not open for further replies.

LowThudd

Vaping Master
ECF Veteran
Jul 2, 2010
3,296
11
I am a GUY from L.A. not girl. lol
Menthot(Titanium atty) from Goodprophets-2.2ohm(always a good vape, untill cart needs around 23 drops to refill)
Sweets(Black) from MFS-2.0 ohm(taste burnt sometimes)
tobacco(Black) MFS-3.3ohm!(Might be an annomolly. tried to read 5.5) has the best vape
Variety Drip atty(DIY)(Black) MFS- 3.5ohm(again, tried to read 5.9) a little low on vape, never tastes burnt
New unused(Not blown through)(Black) MFS-3.7 ohm(still unused)

I think what I am seeing is the need for the atty to be between 2.5ohm and 3.0ohm. Best results there. These attys wick the best, don't tatste burnt, and don't leak very bad(unless left alone filled). Also noticed that the attys I used the most, vaped the besed. So it is possible they need more "Breakin Time" than the standard 510 attys.
 

LowThudd

Vaping Master
ECF Veteran
Jul 2, 2010
3,296
11
I am a GUY from L.A. not girl. lol
Well, I kept using my "Sweet" atty w/ some loranns Keoke Coffee DIY 30mg pure VG juice(doesn't taste so bad even when dry), and eventually the taste settled down, and the happy gurgling sound of good wicking ensued. This was started a few hrs ago on a freshly cleaned factory filler. I rechecked the resistance, 3.5ohms. I am assuming the juice in the coil effects the res.. It seems they may just need to break in until they hit their sweet spot of @3ohms. Not sure why, those are just my findings.
 

Valsacar

Ultra Member
Supporting Member
ECF Veteran
Verified Member
Aug 16, 2010
1,778
243
Seoul
I've been playing with it more, I got the rolled plug thing working fairly well. As long as I don't hold it vertical for too long it doesn't leak... actually made it about half a day on one fill (wasn't filled too much). Does take a bit of work when refilling to get it back in there just right though.
 
Status
Not open for further replies.

Users who are viewing this thread