Ekowool with igo-w

[vicbreh]

Jus received 2.5mm Solid Ekowool and would like to know what's a good safe build and wire resistance for an igo-w? Using a nemesis btw. (Looking for switch magnets) but besides that-- anyone know a good build for it? Dual? Thanks in advance for anyone responses.


Sent from my iPhone using Tapatalk

 

[tc1]

What resistance are you aiming for?

I do 6 wrap 30 guage dual coil on my Igo-W .. that's about 0.6 ohms. My air holes drilled out to 1/16.

Very good vape ...

 

[JmanEspresso]

It literally depends solely on the battery in your device.

the Igo-W itself can handle whatever you build, its not the issue. The battery your using decides what kind of coil you can build.

What kind of battery and mod are you using?

 

[tc1]

As long as you are not using ICR, anything at or above 0.5 ohms should be safe ... as that is below the 10 amp limit on standard IMR.
If you are using AW 18490 or AW 18650 1600mah (Along with the newer MNKE/Samsung/Sony) you could go lower.

I'd go with dual coil ... as that is the sole purpose of the -W over the -I. If you do single coil, you might want to block the backside air hole.

 

[Ryedan]

As long as you are not using ICR, anything at or above 0.5 ohms should be safe ... as that is below the 10 amp limit on standard IMR.

Careful with generalizations tc1, we don't know what size batteries the OP has. I think the Nemesis goes down to 18350's. Not all 18500 do 10A and no 18350 that I know of does.

Let me know if I'm wrong about the Nemesis

 

[tc1]

That's why I said AW 18490 ....

Good point on the 18350. They are generally 6 amps or below. And you are indeed correct, the nemmy goes down to 18350.

Here's a good ohm calculator for the OP. http://www.rapidtables.com/calc/electric/ohms-law-calculator.htm

 

[vicbreh]

Thanks. Mostly using 18350 red aw IMR battery for the nemmi..


Sent from my iPhone using Tapatalk