Eleaf GS Air Fan
- Thread starter Javamon
- Start date
- th_trl_thread_readers 0
- Status
What have you got against Kelvin?our lynn is historically correct!
nonetheless, as a german, i prefer celsius!
where did everybody go?
Yeah, way too quiet over weekend, very scary. Somebody, do sumpthin!!!
I was crazy busy yesterday. Happy that I didn't find five pages to catch up on when I checked in at midnight!
Eleaf offically announced the new GS Air Tank:
GS-Tank Atomizer
Parameter:
Length: 50.0mm
Diameter: 22.0mm
Capacity: 3ml
Resistance: 0.15ohm
Heating Wire: Nickle 200
Working Wattage: 30W-40W
Color: Silver
Thread Type: 510 Thread
GS-Tank Atomizer
Parameter:
Length: 50.0mm
Diameter: 22.0mm
Capacity: 3ml
Resistance: 0.15ohm
Heating Wire: Nickle 200
Working Wattage: 30W-40W
Color: Silver
Thread Type: 510 Thread
Last edited:
I am sure all the regular vendors will be selling them LynnNC.
I'll email Eleaf and ask them if the tank material is going to be stainless steel (they never respond back though to my questions). I'll also ask if they are planning on making a bigger version of the new tank and if the tanks can be fully taken apart to be cleaned.
Good morning to all, hope you're all having a wonderful day. 
Looking forward to the new tank.
I have taken apart all of my tanks, the GS Air, GS M and GS MS. I did not find any signs of glue, they are just on real tight. I posted pic's some time ago on this thread.
I am sure all the regular vendors will be selling them LynnNC.
I'll email Eleaf and ask them if the tank material is going to be stainless steel (they never respond back though to my questions). I'll also ask if they are planning on making a bigger version of the new tank and if the tanks can be fully taken apart to be cleaned.
Looking forward to the new tank.
I have taken apart all of my tanks, the GS Air, GS M and GS MS. I did not find any signs of glue, they are just on real tight. I posted pic's some time ago on this thread.
You have the best luck taking these boogers apart...the ones I took apart have whatGood morning to all, hope you're all having a wonderful day.
Looking forward to the new tank.
I have taken apart all of my tanks, the GS Air, GS M and GS MS. I did not find any signs of glue, they are just on real tight. I posted pic's some time ago on this thread.
looks like silicone sealant on the threads. I quit trying to take them apart.
maybe you need to start an Air tank rehab service!
Working wattage 30-40 watts? Eliminates Tootle Puffing, no?? Yes??
Yes.
No frogs were harmed in the construction of the monosyllable above.
As for the dude doing jumping jacks...maybe, maybe not. Rrrrribbbbitt!
.
Last edited:
No. The older 1.5ohm kanthal/silica and newer 1.2ohm kanthal/cotton coil will work like they always have (threading looks the same to me for all). Eleaf just was only looking at things from the 0.15ohm Ni200/cotton coil when they said that.
Not necessarily,a .15 ohm coil will probably work fine at 30w and still be low power, but my GSA M atty did get pretty hot trying to run 28.5 at 420. I had to drop it down to 10 at 375. It's working good now. And I'm using it in legal "tootle puffer" range. I did a .064 ohm coil (Yihi recommends .065 ohm for optimum TC performance). Note the use of only .89v
Last edited:
- Status
Similar threads
