Eleaf iStick mod with custom top cap, spring loaded 510, 3200mah battery
- Thread starter david4500
- Start date
- th_trl_thread_readers 0
- Status
Is there a file I can upload to get one of these custom top caps made? I'm wanting to do this to a couple so a friend and I will have a dependable backup.
Heck, with that top cap, a DNA 40 board swap, and a 30 amp 18650 swap..... It would be an ideal all day vape device 
Sent with one hand, the other is busy vaping.
Sent with one hand, the other is busy vaping.
Heck, with that top cap, a DNA 40 board swap, and a 30 amp 18650 swap..... It would be an ideal all day vape device
http://www.e-cigarette-forum.com/fo...-loaded-510-3200mah-battery.html#post14576785
I can make a few more. I'll send you a message once done if you are interested in buying a few.
Last edited:
Money's kind of tight at the moment, but let me know if you can how much they would cost. I'd need 2.
Also, I noticed over on the breaktru forum there was a lot of talk about how the built in Li-Po battery has a better discharge curve for this particular application than any of the 3rd party batteries, even though they have a higher rating. Have you done any testing on that or care to weigh in?
What would be the cost of a top cap like that?
Sent with one hand, the other is busy vaping.
Sent with one hand, the other is busy vaping.
David, that link keeps bringing me back here
Sent with one hand, the other is busy vaping.
Sent with one hand, the other is busy vaping.
It's another post in this thread with a link to reddit where someone did install a DNA40 in an iStick. The result of that was that it was extremely difficult, so it was only going to be a one off. Plus, the battery gauge was partially covered.
About $10 each.
Aside from some test firing, I haven't had the chance to use the istick with the 3200mah panasonic (quit vaping)
Oh, it was bringing me to the last post of the thread
. I saw that post.....i bet a dna30 would fit better And if you are already that deep into it, one could always make the display window larger
Oh, it was bringing me to the last post of the thread
And if you are already that deep into it, one could always make the display window larger
The problem isn't the size of the board as you can cut the tabs off the DNA40 and it will be the same physical size as a DNA30. It's setting up the buttons that's gonna be a trick.
When my istick dies I think I want to try it
Sent with one hand, the other is busy vaping.
Sent with one hand, the other is busy vaping.
Dave i may want a top cap as well, let me know when you are ready , my istick is on the way and i would rather be prepared in case it does strip out.
Thanks,
Dave (lol)
Thanks,
Dave (lol)
Damn it might have to get another one david. The wife dropped hers on the tile floor it went in tank first and got the cap. I think I can do a decent repair but just in case I might be in for another.
The best option for that would be if I designed a 3d model and then had the prints available on shapeways. When I have time I'll try to do that.
At the moment, I only have 2d files for laser cutting acrylic. 4 layers, 3mm thick each that must be chemically bonded together. After that they still need to be sanded and polished.
Oh my. Sorry to hear that. I'll add you to the list along with everyone else that wants one.
- Status
Similar threads
