eRoll - Stainless Wicks
- Thread starter junkman
- Start date
- th_trl_thread_readers 0
- Status
Thanks for the responses. So when we dry burn to clean are we actually destroying this wick in the coil? Should we rewick this with ss mesh after dry burn or will the coil function properly without wicking material in it and just the ss mesh in the spike? Should the ss mesh from the spike touch the coil?
Sorry for all the questions but I've been getting inconsistent results using the mesh. Thanks for helping out a noob.
Sorry for all the questions but I've been getting inconsistent results using the mesh. Thanks for helping out a noob.
It makes it taste bad (to me). But it doesn't destroy it any more than dry burning the wick in the spike does.
the ss is a trial and error. I found Volume controls video to be the best. I make small adjustments to the tube opening in the wick for issues. Close up the tube with pliers if to much juice is getting through, or opening it up more if I am getting a burning taste.
I don't think it is a silica wick inside the coil. If it was wouldn't a dry burn would destroy it? I am thinking I might not want to know what kind of a fiber material that doesn't burn is in inside there.
Hi Junkman! Im am such an eRoll fan still. It seems like my atties want to last forever and thats a good thing. I still dont vape the WTA e juice in the eRoll. Its too thick and wants to burn. Just doesnt vape as nice as the 70/30 pg / vg with the mesh wicks. I cant tell if im vaping a mesh wick or the Standard atty's wicks anymore!
The wick inside the atty coil is silica. Why would you think that dry burning would burn the wick?
I dry burn my coils frequently enough that it only takes a couple of two second pulses to clean them. After dry burning I rinse my attys again to get rid of any residual ash from dry burning and just let the attys air dry after that.
I think that is burnt juice on the wick rather than the wick itself being burnt. Use some long tweezers to hold the blackened wick and torch it with a lighter. The black stuff disappears and the wick turns white again.
Ok I have never tried that. I just assumed that the burnt taste was from the wick burning. Good to know
I damaged a spike by leaving tooth mark from the pliers which caused the atty to flood . I came up with this method which will not cause the tooth marks.
Anyone have a link to pre-rolled ss mesh for the eGo-c atomizers? I know they sell them but I can't find where.
I just replaced a burnt wick with the stainless mesh and I don't anywhere near the amount of flavor as the original wick. Anyone else having this problem?
Also, what kind of cotton are you guys using? Any worry about it getting burnt on the coil?
Also, what kind of cotton are you guys using? Any worry about it getting burnt on the coil?
- Status
Similar threads
- Locked
