EVOD clogged?

[the_cold_revolution]

I've been using the EVOD about a month now exclusivly because I like the weight distribution better than the mt3s and my protank broke. I had a problem about halfway through my 4th coils life span of constant flooding and hard pulls (restricted air flow). After changing coils and batteries, I had the same problem and I was getting frustrated. The solution?

Dried up juice or dirt clogging the three airholes on the base of the EVOD!

After a quick angioplasty with a mechanical pencil (0.7mm lead worked great) the light airy draw was back and my leakage/flooding problem was solved.

One of the draw backs to using the same tube always I suppose.

I also found out (by mistake) if you want a stiffer draw, a sliver of the same pencil lead works great as a plug.

 

[Judge Dredd]

A lesson to be learned here: clean your devices when you can.

I've never owned an Evod, but I do have an MT3 which from what I understand are quite similar. It's possible you have a leak somewhere, because I've never had such a problem.

 

[State O' Flux]

I use a piece of surgical tubing to block 1~2 of the 3 vent holes on T3Ss and EVODs... to duplicate the draw of a non-filter cigarette.

I bought, what I now know to be a low quality copy of, a T3S a few weeks ago... none of the vent holes were drilled all the way through. They were there, they just stopped short of the threads.

C

 

[Rickajho]

I clean my bases in simmering water. Just for general cleaning, but it keeps the vent holes nice and open too. (Safer in that way than a pencil lead...)

 

[Marjolein]

I clean them every time I refill them with hot water and I've been using mine for over 4 weeks without replacing the coil. I agree that keeping them clean prevents a lot of trouble.