Favourite wire for flavour

[Berenulf]

Hello!

Mine is so far VandyVape 400 mesh, but I would like to change that and use my zeus x rta for duals instead. Don't want to go too low on ohms with a very thick wire, because I hate killing the batteries and recharging constantly. TC compatible wire would be nice bonus...

Thanks a ton, you folks here are all really great and awsome people!!!

 

[ShowMeTwice]

I like SS316L for vaping in wattage or TC modes. Also, I buy spools of wire and wrap my own coils.

Some of the SS316L wire I like is 26/36 Clapton, 28/36 Clapton and 28x2/40 fused 2 core. I also like 27g and 26g simple round wire. I don't like SS in higher than 27g, wire above that is too flimsy. I also like vaping Ni80 30x4/40 fused 4 core wire.

And I also like the occasional pre-made Ni80 29/38 3mm ID Aliens and 29/38 TriCore 3mm ID coils.

 

[Berenulf]

I like SS316L for vaping in wattage or TC modes. Also, I buy spools of wire and wrap my own coils.

Some of the SS316L wire I like is 26/36 Clapton, 28/36 Clapton and 28x2/40 fused 2 core. I also like 27g and 26g simple round wire. I don't like SS in higher than 27g, wire above that is too flimsy. I also like vaping Ni80 30x4/40 fused 4 core wire.

And I also like the occasional pre-made Ni80 29/38 3mm ID Aliens and 29/38 TriCore 3mm ID coils.

Is clapont ss316 manageable in TC? or do you need a higher chipset mod for it like DNA or YiHi?

 

[Tor R]

SS316L, 26 ga - 28 ga, from 6 -8 wrap, ID 2.5.
Brand: Buddha Wire (off course @Daniel Forsyth ) and Kidney Puncher.

The next thing to try is dicode's own wire.

PS, me mtl vaper

 

[ShowMeTwice]

Is clapont ss316 manageable in TC?

Any of the SS wires I mentioned will work nicely with TC.

or do you need a higher chipset mod for it like DNA or YiHi?

Your Aegis Legend will work fine. No DNA, Yihi or Dicodes mod needed.

I would like to change that and use my zeus x rta for duals instead. Don't want to go too low on ohms

When you run dual coils your resistance will be cut in half.
Example: two 1.0Ω coils will be read as 0.5Ω on your mod.

 

[dwcraig1]

I use Unkamen's 28 gauge SS430. I take two strands and twist them tightly using a drill. I twist it cold then torch the finished length to make it easier to wrap. "
'Been doing this for about 5 years now.
Without much mass they heat up and cool quickly. Great flavor. Cost is pretty much zilch.