Field Strip: I-Atty

[FLExJuice]

I just field strip and cleaned my i-atty. From the factory these things are dirty especially the drip tip. It took some finessing to take it all apart but worth it since I know this baby is clean and ready for testing soon.

I plan on using the stock wick and coil but what's up with the twisted wire?

 

[C1BERUS]

when you dont have a lower AWG wire, you want to make a lower ohm but on the same length. you should twist the wire. becareful when twisting the wire, you halfing the resistance from the original.

 

[FLExJuice]

I'm getting 1ohm out of the stock setup. I was watching a how-to on the z-atty but need to finish it. He used a Provari and for the initial setup was bumping the voltage to not short the coil.

(Update) That was fun and frustrating. I tried it on my Zmax and it wouldn't thread into the connector. So I used it on my other mods and it fit nicely. It produced so much vapor without the cover it made me cough.

This is my 2nd rba build but 1st time with I-Atty. I'll keep experimenting with rba but I still prefer my Kanger Protanks. If you want to start your journey in rba and got time to kill it's worth the try before diving into something more expensive. It only cost $15.