Final install issues

[mvroman]

So I have been rebuilding for awhile now, but I am having issues wrapping the legs around post screws instead of running them through. Any tips or help?

When I do a regular single coil it kinda works but seems like it's not getting the same amount of power as when I run through the posts, and when I do duals or a parallel I can't get both legs to stay under the screw head. I am using an Omega clone and one of the posts is twisted facing the wall so I can't run duals without wrapping around the screws and it's difficult to run a single running it through the posts because the wall is so high on the base.

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

[SLIPPY_EEL]

try different screws in the post holes... maybe the ones in your clone aren't very good quality... maybe that's why you are only getting a good connection through the posts.

i had a post on a trident that would spin.. i would have to thread the leg through, then hold the leg with pliers while tightening down to stop it spinning lol im glad i don't have to bother doing that anymore

 

[Dissonance]

For me, I wrap the lead around the screw once completely. Makes it stay nice and tight and I never have it pop out from under the screw. It's about the only way I can get dual coils to stay in place too... Maybe that's just me tho.

 

[havok333]

For me, I wrap the lead around the screw once completely. Makes it stay nice and tight and I never have it pop out from under the screw. It's about the only way I can get dual coils to stay in place too... Maybe that's just me tho.

I do the same, wrap the wire all the way around. Then tighten down.

Sent from my XT1049 using Tapatalk