Just did my first build on an IGOW-6. I haven't burned the coils and pinched them together yet so it still looks a little janky but hey, it was my first attempt!
First Build on IGOW-6
- Thread starter shurpacabra
- Start date
- th_trl_thread_readers 0
- Status
Have fun with it. I found that nicotine, I couldn't go below 28/26 gauge. If you use zero nicotine and want clouds, try 24 gauge. That's the lowest gauge that will fit the IGO-W6.
5/64" with 10 wraps at 0.20 Ohms. I had 26 gauge wrapped 10 times with 26 gauge around a 1/16 bit prior to that.
Sent from my SPH-L710 using Tapatalk
Sent from my SPH-L710 using Tapatalk
- Status
