*FIXED*Ohms increasing..

[bloodless2010]

Okay so I understand that with loose connections the ohm readings may be wrong or fluctuate a bit, but this is an odd problem I'm having, i'm using the iPV3 Li, with the goblin rta, I have a dual coil in there that fires perfectly fine, but I'm having an odd problem, the resistance increases after I use it, so it starts off at .3, then after use .35, then .4, and .5 etc which is very odd, if I hit the up/down buttons it sets the resistance back to .3, does anyone have any idea why this is happening and how I can fix it? thanks.

Edit; problem has been fixed, thanks everyone

 

[Robert Cromwell]

What type of wire do you have in the Goblin?

 

[bloodless2010]

What type of wire do you have in the Goblin?

Kanthal, and I'm running in regular wattage mode.

 

[Robert Cromwell]

Something loose? You got me.

 

[Jdurand]

When you say "goes up as you use it" does that mean each puff, every hour? How fast does the jump occur?

 

[Zombo]

Okay so I understand that with loose connections the ohm readings may be wrong or fluctuate a bit, but this is an odd problem I'm having, i'm using the iPV3 Li, with the goblin rta, I have a dual coil in there that fires perfectly fine, but I'm having an odd problem, the resistance increases after I use it, so it starts off at .3, then after use .35, then .4, and .5 etc which is very odd, if I hit the up/down buttons it sets the resistance back to .3, does anyone have any idea why this is happening and how I can fix it? thanks.

I wonder if it's a general problem with ipv. I had a similar experience when I used to use my IPV4S.

 

[bloodless2010]

When you say "goes up as you use it" does that mean each puff, every hour? How fast does the jump occur?

Pretty much as soon as I hit the fire button, I've noticed now theres a lot of small jumps, like .30 to .31 to .29 but theres also big jumps like .1 increases

I wonder if it's a general problem with IPV. I had a similar experience when I used to use my IPV4S.

Tried it on my Innokin Disruptor and same thing happened, gonna try tightening everything and see if that does anything

Edit; Turns out one of the posts came unscrewed Everything is fine now and it's staying at .26

 

[Jdurand]

There has to be a loose contact screw or broken wire in that tank, just has to be. Either that or the insulator is getting screwy. is it a new problem with a new tank or a new problem with a tank that worked for a long time?

 

[Jdurand]

I've had resistance creep up as the coil and wicks start to gunk up, but not from the first fire. Very odd.

 

[USACelt]

I would think some thing loose,

 

[crxess]

Pretty much as soon as I hit the fire button, I've noticed now theres a lot of small jumps, like .30 to .31 to .29 but theres also big jumps like .1 increases


Tried it on my Innokin Disruptor and same thing happened, gonna try tightening everything and see if that does anything

Edit; Turns out one of the posts came unscrewed Everything is fine now and it's staying at .26

Good Catch