I saw this in the mod section. This is awesome and if anyone has the tools to make this happen there will be a lot of vapors going nuts over this. I would gladly pay 40 - 50 bucks for this.
http://www.e-cigarette-forum.com/forum/cartridge-mods/57184-micro-juice-box.html <---- LINK
The other cartridge half has the tip removed and the passages have been opened up to extend the vapor path and liquid reservoir. Then a stainless steel sleeve has been pressed on:
That plug is installed in the cartridge with a straw spacer to properly set the height. The height is set so that the bridge compresses the plug slightly, and the plug conforms to the bridge creating a seal.
I hate dripping and I hate pollifill but this is the best of both worlds. You simply push that beed while holding ecig battery end down and it creates an airflow through it. and then it drips a few drops on the attie with out ever taking the cart off. The guy says he gets about 3.5 hours of vaping time with this....
http://www.e-cigarette-forum.com/forum/cartridge-mods/57184-micro-juice-box.html <---- LINK
The other cartridge half has the tip removed and the passages have been opened up to extend the vapor path and liquid reservoir. Then a stainless steel sleeve has been pressed on:
That plug is installed in the cartridge with a straw spacer to properly set the height. The height is set so that the bridge compresses the plug slightly, and the plug conforms to the bridge creating a seal.
I hate dripping and I hate pollifill but this is the best of both worlds. You simply push that beed while holding ecig battery end down and it creates an airflow through it. and then it drips a few drops on the attie with out ever taking the cart off. The guy says he gets about 3.5 hours of vaping time with this....
Last edited:
