Freaking out need help

[Denny-o]

Hope someone can help me. Got a couple ego clearomizers from gotvapes....they look great, and got here super fast, but here is my issue...I have a vamo and I got the 510/ego adapter. The threads seemed loose but not stripped so I went ahead and tried it out. The ego tanks read no ohms, so I leave the adapter in and put a nova tank on and it works great. I take the adapter out and now nothing works!! What can I do?? Did this adapter short out my mod? Any help is greatly appreciated.

 

[Kable]

It sounds like you just pushed in the center pin on your delivery devices. Grab a pair of needle nose pliers and pull it out a hair, and you should get a connection again.

 

[Denny-o]

Thanks Kable, but no go pulled pin out a little and still reads low ohm

 

[Kable]

Oops, low ohms would probably be a short, not an open. Have you tried cleaning the threads?

 

[Sikko]

Do you have another device to try, it might be that the 510 to ego adapter is bad? If you can use the atty on another device I would say that would be your problem.

 

[Denny-o]

Thank god I have a backup bolt, I'm only smoke free for 17 days. My nova tanks work on the bolt fine, but I'm afraid to try this adapter again. Is there a better adapter out there or could I have over tightened it maybe? Thanks again guys

 

[Denny-o]

And I tried cleaning the threads, no go

 

[Caridwen]

You could try posting in the VAMO forum. Maybe someone there can help.

VAMO

 

[Caridwen]

Is this any help?

http://www.e-cigarette-forum.com/forum/vamo/363306-mini-nova-vamo.html#post8538751

 

[Magic_seaweed]

Depending on the type of carto you purchased it could be supposed to run low ohms. I have had some in the past as low as 1.3ohms and as high as 3.2ohms! Check with where ever you bought the cartos from and see what type they gave you a connection problem should leave you with no ohms at all. In other words its kinda a connected or not connected situation with electricity. Good luck