Fuhattan mod clone problem

Status
Not open for further replies.

sasaeel

Full Member
Mar 22, 2015
13
1
Hey!

Ive been vaping my copper FUhattan for 4 days now and now i noticed when i was pushing it to my table, spark fly out of the bottom button. I did the same about 20 times again and then it sparked again, so 20 times without spark. My battery does not get hot but it gets warm on chain vaping cos im vaping at 0.18ohm on my dripper, so i dont think its short, i have never shorted anything so i dont actually even know. Any1 have any suggestion what would cause that ?
 

sasaeel

Full Member
Mar 22, 2015
13
1
That might be, but i wont be able to see if it sparks when im vaping cos its happens at the bottom :D and that pushing it to table happened accidentally while i was playing and i put it down bit harder, and it fired and i saw it, i tried many many many times again and like after 20 times it happend again, ive been trying to get it happen again with pusing it normally on my hand but not happening, so maybe its becouse of that, button doesnt get hot or anything. And i did read something like every mechanical mod arcs inside but u cant see it, and that leaves black marks to batteries wich i have. But yea i think maybe ure right! Sorry for my bad english, im from europe, not enough vapers here to get fast answers on forums :D
 

sasaeel

Full Member
Mar 22, 2015
13
1
Heh thanks! :D I hope its only that partial connection thing or that arcing just got trough the venting mechanism. But i cant think anything "dangerous" as if its shorting, my battery and button should be hot, right? as i said, never shorted anything. My batery gets "warm" doe when im vaping like 10 times straight and i think thats just normal on low ohms. thanks!
 
Status
Not open for further replies.

Users who are viewing this thread