G-Tank-US-CO-OP Support Thread
- Thread starter Scubabatdan
- Start date
- th_trl_thread_readers 0
- Status
Thank you Dan for your awesome work!
Is it still possible to get it assembled? I already paid the unassembled price but i can send you the difference
Is it still possible to get it assembled? I already paid the unassembled price but i can send you the difference
Dan....
I get 79.49 with shipping and donation. Is that correct? Is there an extra charge for signature required as I requested? I will gladly pay.
Thanks for your hard work
Bob
I get 79.49 with shipping and donation. Is that correct? Is there an extra charge for signature required as I requested? I will gladly pay.
Thanks for your hard work
Bob
Last edited:
Unfortunantly, I can not accept payment for assembly, and am not taking any more request for assembly. Don't worry I will have very detailed instructions, you will be fine.
Dan
Just a thought folks, Perhaps if we all throw in a little extra coinage, There might be a few Frosty Cold Adult Beverages out in the workshop. Just imagine what could transpire and emerge from the Mad Scientists Lair!!! Hmmmm...Frosty Cold "People" drink in bottle....Hmmm.....Oooopps....I'll be outside chasing the cat.....Whoopee.
This may be a little late but,
Is it safe to have that brass piece in there? Won't it mess with juice?
Is it safe to have that brass piece in there? Won't it mess with juice?
I sm using the brass insert in mine for almost 2 months now, and it is under the screw with the kanthal between it and the screw and I have not had any problems. It is not like a brass tube your juce goes through or sits in. Sure it does get juice on it but is an electrical connector and not part of the juice supply. I have been looking for them in SS but as of yet I have found only brass. Best option would be to tap the hole, but SS is too hard and the tap will break off. So my only choice is brass.
The other brass piece, the center pin does not come in contact with the juice.
Dan
Last edited:
all paid up. think i got it covered 
any problems dan pls let me know
thanks for all the hard work.
any problems dan pls let me know
thanks for all the hard work.
After a few weeks I had a small amount of juice in the brass cup the connector and s-wire are housed in but there is no vaporizing being done in there.If there are places in a e-cig that juice can get into it will.
Payment sent.
I did NOT pay for the assembly I had requested.
I did donate to Dan's frosty beverage fund. Always happy to buy a few rounds for a good guy.
I did NOT pay for the assembly I had requested.
I did donate to Dan's frosty beverage fund. Always happy to buy a few rounds for a good guy.
Update will happen later tonight as I will be at a basketball game my daughter is cheering at.
See ya when I get back!
Dan
See ya when I get back!
Dan
- Status
Similar threads
