GeekVape Zeus RTA

[Walter_Sobchak]

Stick with a single round wire build at first. There is a confusing learning curve with the Drag I've seen mentioned many times. There are some helpful posts in that thread. What regulated mods do you have? I am not wading thru the shiny thread to find your post.

I went back and watched Vic's review of the MVP 4. He did his typical TC test and said that it was better than most but not at the same level as a DNA or YiHi device. His exact words were "It's just fine" in that great Scottish accent.
I'll check out some more opinions of the MVP's TC function and if nothing else I'll have to get a new mod! Oh, and that will be a Shinyitis approved purchase. I will after all "need" a mod that does proper TC.

 

[Letitia]

I've not owned a MVP 4 but know some who do. Fantastic workhorse and lasts damn near forever. Tougher than a Battlestar and just as reliable.

 

[Beamslider]

I have 3 dna mods. all do TC well.

I have used TC on Joyetech mods and the PICO with arctic fox firmware installed on them, they also did TC well.

Yes the DNA probably better but also much more expensive.

 

[Letitia]

There you go Randy...Pico is all you need!

 

[Walter_Sobchak]

I'll end up doing all this research into TC and wasting all these people's time and watch, I'll end up not liking it. Thanks for your patience!

 

[Walter_Sobchak]

There you go Randy...Pico is all you need!

I'm not "anti Pico". I just think they look like a miniature of something that someone didn't really like. And for some reason the name bugs me.

 

[Dropmyload]

I use a tugboat dna75 for tc with my ego one v2 tank and a titanium clr coil.

For my Zeus, I use the Reuleaux RX 2 20700. I want to install arctic fox but am unsure I'll be able to reverse it if I don't like it.

My Zeus is now in tc mode also, using a cheapo demonkiller coil I got in a pack from GB.

 

[Major911]

I’ve had good TC experiences with the Tesla boards. The nano 120 and the Wye which I still use. Both have the same board and are Rock solid in TC.


Sent from my iPhone using Tapatalk

 

[Walter_Sobchak]

I’ve had good TC experiences with the Tesla boards. The nano 120 and the Wye which I still use. Both have the same board and are Rock solid in TC.


Sent from my iPhone using Tapatalk

That's just my luck. I had a Tesla nano that was included in a buy I made from the classifieds and I just gave it to a coworker who was ready to graduate from starter pens to something bigger. Oh well. It went to a good cause.

 

[Letitia]

I use a tugboat dna75 for tc with my ego one v2 tank and a titanium clr coil.

For my Zeus, I use the Reuleaux RX 2 20700. I want to install arctic fox but am unsure I'll be able to reverse it if I don't like it.

My Zeus is now in tc mode also, using a cheapo demonkiller coil I got in a pack from GB.

If you don't like the firmware you can reset the mod back to factory firmware.

 

[hiclass]

GeekVape is so busy with their other new tank, mod and so on... I don't think they care to improve current Zeus.

I wish someone will clone the Zeus and adds the below improvements:

1. Replace Phillip screw with Hex's (2.5x3 or 2.5x4)
2. Slightly taller tank
3. New colors: White, Red, Gold, Brass etc
4. Drip tip come in color same with the tank
5. Swap the position of screw holes and juice holes
6. The 2 AF posts should be part of the chamber (top down) instead of sticking up from the deck.

I swear I will order a dozen of Zeus V2 as above!

 

[hiclass]

7. A secondary top cap which is 510 drip tip ready instead of 510 drip tip adapter.

 

[janne303]

Tried to coilbuilds yesterday and got short both times... 3.5 diameter flat clapton 3 cores and above the lower airhole. Maybee I got to close to the top? Or something wrong with the 510?

 

[Walter_Sobchak]

Tried to coilbuilds yesterday and got short both times... 3.5 diameter flat clapton 3 cores and above the lower airhole. Maybee I got to close to the top? Or something wrong with the 510?

if you get a chance share a pic

 

[janne303]

if you get a chance share a pic

This one

Skickat från min SM-G935F via Tapatalk

 

[DP2Raja]

I can't see a cause for a short from your coil position. I have put my coil at that same height (if I am see it correctly in the pic) and had no short. Unless your coil is higher than I think, it seems to indicate there may be a problem with the 510.

 

[Marc411]

Have you tried to tighten the flat head deck screw located on the 510 pin. If that is loose it could give you a no atomizer or short problem.

 

[SteamHead]

Normally I'd think it pointless to buy a clone of a tank that's so reasonably priced, but I have one on the way. I've been looking for a gunmetal tank to look good on my new Smoant Cylon (which I love, btw), but the authentic Zeus gunmetal just looks like a dark grey to me.

I happened to find a clone on ebay that looked like actual gunmetal. It will be here in a couple weeks, and I'll let y'all know my impressions of it. Hopefully it's not too bad.

 

[Walter_Sobchak]

I can't see a cause for a short from your coil position. I have put my coil at that same height (if I am see it correctly in the pic) and had no short. Unless your coil is higher than I think, it seems to indicate there may be a problem with the 510.

what he said

 

[Letitia]

Normally I'd think it pointless to buy a clone of a tank that's so reasonably priced, but I have one on the way. I've been looking for a gunmetal tank to look good on my new Smoant Cylon (which I love, btw), but the authentic Zeus gunmetal just looks like a dark grey to me.

I happened to find a clone on ebay that looked like actual gunmetal. It will be here in a couple weeks, and I'll let y'all know my impressions of it. Hopefully it's not too bad.

Please do, I like the shiny finish