What more than this can I expect guys? Wonderful review, really funny and entertainment discussion. I laughed so many times with all of you. (Cat was the only serious person there, you crazy people


). You have the best company in the world and I would like very much to join you but my english are not too good for this

.
Ok, Some thin gs I would like to mention after seeing this discussion.
1. Reffiling time is less for me, about 15 seconds xaxaxa
Ok, on a more serious note:
1. The metal is only shined stainless steel.
2. As you already said, aluminium is ok but myths about it still exists on people's minds.
3. Even if the UFS is cleaned by supersounds, better to clean it before first use (as you already said) because my hands were around and inside it, my sellers hands too, some vaseline is inside etc.
4. In general and especially for very LR atomizers (1,5 ohm) or for 3 ohms at 6 volts, please keep the mouthpiece not tight on the cap. Just screw it until it meets the o-ring inside cap. Thats it. And when you want to stop the atomizer from overflooding more, then you screw the mouthpiece tight and of course you close the liquid control ring.
5. About cost, yes its not cheap but not expensive considering the reasons:
a) steel
b) too many parts
c) accurated. For example the connector is 8,5mm in width and the hole of the base piece of UFS is 8,7mm. Also
threads of connector and CT have to be exactly to the right position so connector has to go totally straight via this 8,7 mm hole. That was only one example of the accuracy UFS needs to work right.
Thanks Dave, Andy, Cat and Dave and the other friend that was there for this.