Ggts trick

Status
Not open for further replies.

tarricone

Senior Member
ECF Veteran
Feb 5, 2013
85
12
54
italy
Hello,
I buyed a new GGTS
Is new (1 week) but sometimes the button, when pressed, does no good contact.
I have put noalox on buttn contact and center spring but is the same.

I have therefore thought to increase the conductivity with a sheet copper wrapped around the cylinder of the spring.

What do you think?

Here the foto


egyde6eg.jpg


4ary2e4e.jpg


se9yvy3u.jpg
 
Last edited:

tarricone

Senior Member
ECF Veteran
Feb 5, 2013
85
12
54
italy
Now the button touches copper tar when in previous stage it was touching brass. Not a big difference. Your problem is elsewere for sure.

Did you see any black marks on the axis where you put the copper around? Or any black marks on the button's firing pin?

@imeothanasis
Yes there are black marks on the axis and at the end of the button were touch the copper.
I have remove this black but is the same



Inviato dal mio GT-P5100 con Tapatalk 2
 
Status
Not open for further replies.

Users who are viewing this thread