Godzillamizer v2

[asnider123]

Last month I built myself a tank mod, nothing special, just a madvapes 22mm vial with top and a perforated CE2 clearo XL ... has been working like gangbusters for a month, not too bad for about 3 bucks!! Have seen similar tankmods made by several of you, kudos to my predecessors, you know who you are!

Godzillamizer v1


The problem is that, when the CE2 goes south, you toss the whole thing because the CE2 is sealed into the tank.

I have been reading about a tankmod from Goodprophets that a CE2 screws into. When the CE2 bites the dust, just unscrew the old unit and screw in a new one. Vape on!!! I decided I could do something like that!!

Here's my concept...

Godzillamizer V2 pictures
Started with the MV vial and a new XL CE2


Drill a CE2-sized hole top and bottom


Mount a short 510 extension in the bottom of the vial. For this I used GP's eGo/510 adapter


and assemble the unit


This is still a work in progress:

What needs still to be done:
1. Seal the eGo/510 adapter to the vial
2. perforate the Clearomizer
3. Resurface the eGo adapter to get rid of the 2 air grooves
4. Get some o-rings to seal the CE2 to the adapter

Also, I may have a problem with too hard a draw, but I will work this out.

As a side note: the eGo/510 adapter screws on perfectly to all my mods EXCEPT my GGTB. I thought all 510 threads were the same, guess not ???

I will continue this thread as I progress.

 

[asnider123]

Did I mention it cost me less than 2 bucks, not counting the replaceable CE2?

 

[asnider123]

Part 2:

Well, here's what I have done so far:

1. eGo adapter was ground flat and sealed into vial


2. I perforated the CE2 .. last time I cut slits with my dremel, this time I am trying tiny holes drilled thru the plastic tube. Low holes to pull juice, high holes for ventilation. One thing I noticed with Godzillamiser v1 is that the CE2 fluid level tends to be higher than the tank itself. Thought that high holes may equalize the fluid levels


This mod takes 2 o-rings: one (as shown) that seals the hole in the lid so that it doesn't leak when layed down (works pretty good)


And another o-ring sealing under-fluid connection between carto and adapter (this will have to wait until I hit the hardware)

More to come

 

[asnider123]

Well, finished it!!

Got the o-ring


Screwed in the perforated CE2XL and filled it with vanilla ejuice


Well, it works pretty well!!!


Did notice that, with the tiny perforation holes, it took a couple of minutes for the wicks to get wet. Also, it draws kinda hard, having only the center hole for air. I will try and figure out how to get a little better air flow.

 

[rojo]

NEAT!@%$@ Does it gurgle?

 

[asnider123]

NEAT!@%$@ Does it gurgle?

It only gurgles if you lay it down for a while (it over-fills the inner tube), if propped up when not in use, it is fine

 

[Justinking]

Dude you're the Man!!! I'm always looking for your posts to learn stuff, Snaggin the Knowledge lol