If your using VG juice I would really recommend filling them with a syringe. If you drip into them it will take forever to settle, especially with the Ressurectors or any other XL carto.
Heres how to do it.
I originally posted this in another thread for someone that asked how to fill the Ressurectors so Im copying and pasting. This is essentially for all cartomizers, just instead of putting 2ml in your syringe that the ressurectors hold, your going to put the amount for whatever cartomizer you use holds.
How to fill a cartomizer with a syringe:
"All you have to do is take the dropper part of the bottle off your juice and fill your syringe with 2ml for a new carto. Take the rubber tip off the carto and carefully insert the needle down the side pushing against the metal. DO NOT go thru the filler because it will move it and you could potentially break a connection and your carto. Slide the needle down the side and go all the way to the bottom. Then slowly start dispensing some juice. Dont dispense it all bc then it won't be evenly distributed. Put alittle in, then take it out and insert the needle in a different spot. I normally do it in 3 spots (in a triangle) I found it distributes the best, but you could just do it in 2, on opposite sides. Make sure the needle is at the bOttom bc then you will not have to wait at all for it to settle. Disperse slowly and you will begin to see the toP of the filler become slushy. It is full then, don't put more. If its a new carto is will def hold 2ml, if your refilling it won't take a lot so pay attention and once it gets alittle slushy stop. While your filling hold a napkin or something under the carto bc if you do it too fast a few drops will come out the battery end. If that happens its only bc you did it too fast and the poly fill didn't absorb quick enough.( that happens to me bc I am impatient and fill it in about 10 sec, so I just hold a paper towel or napkin underneath.) wipe up the drops and put the rubber cap back on the carto. Then put the carto between your hands and rub back and forth spinning the carto quickly. This will insure the liquid is evenly distributed in case you put too much on one side from the syringe.
Now you have a perfectly filled ressurector that is ready to be used right away!"
Goodluck!
The learning curve is pretty steep compared to most every other piece of hardware I've tried, but well worth it once you get the hang of it. At first I was starting to regret the money I spent on it, but once I got the hang of it I just couldn't put it down. It's my go-to hardware for most of my all VG juices
I have 1 Resurretor (1.7) 1 Boge SR Carto and 1 Liquinator filled with Boba's unthinned out and it works fine for me. Just be patient in letting the filler soak it up.
