Good for Modding?

[sachiaiko]

Whatcha guys think? It's big, but with Nihm batts it creates an 4.8v with a KILLER MAH rating. Should last hours.


Now my question here is about the DC plug, can we set up charging it this way? Whatdya guys think about this?

1PCS 4x AA Battery Holder Box 6V Case DC w/ Clip Switch | eBay

Sachi

 

[mv2envy]

If you just want to use NIMH batts in it for 4.8V mod, it can work. but I would ditch the DC plug and put your atty connector there.

 

[MickeyRat]

Actually I think you could make a decent mod out of that. Three 14500s in parallel would give you a long time between charges. Or if you like, you could put a 3ml bottle in one slot and make it a bottom feeder. In that configuration you could use two batteries and still have a slot for your button and even VV. I think you could do something with that box for sure.

 

[WillyB]

Whatcha guys think? It's big, but with Nihm batts it creates an 4.8v with a KILLER MAH rating. Should last hours.

That's not correct.

Here's an actual test of 4 NiMHs with 2.5Ω load. 5.5V off the charger.

4 NiCDs, though, would put you in the 4+V range.

 

[sachiaiko]

huh, i've been using a ghetto version of a Puck lately, with four tripple a nihm's and it seems to be getting insane hits compared to my li-ion 3.7volt battery mod. But my atty seems to be dying now, bummer times ten, so its not hitting nearly as hard as it did in the begining.