Good Life Vapor Eliquids and SS Mesh and Coil

[aktionze]

Hello everyone!!!

Recently I ordered some ejuices from Good Life Vapor after reading so many good reviews.

I am so excited to try; however, I was hoping someone could answer my questions to improve my experience of vaping these ejuices.

I will be using AGA-T+ and SS mesh for wick and 28 AWG kanthal wire for coil.

I was wondering which SS mesh would work best 400 or 500 and tight roll or hole in the middle (I understand it is subjective, but I want to hear some opinions)? And how many wraps of 28 kanthal wire would be appropriate on a mechanical mod?

I would be very appreciated if someone could answer my questions.

 

[aktionze]

I am such a newbie... I posted in the wrong forum. Can I possibly delete this thread or move it to General Eliquid Discussion forum?

 

[mechlove]

I know your in the wrong area, but I may as well write my thoughts here anyways. The mesh depends on the mix of vg/pg that your going to get. If you get a 50/50 or 70/30 vg/pg then you want to go with something with less holes, perhaps a 325. Because the VG is thicker you need less holes to allow the juice to get through. If your using all pg then go with 400 or 500 you'll be fine. Don't wrap too tightly, use a quarter of a square sheet and wrap that up, it'll be enough. Also at the bottom of the mesh once rolled cut the bottom off at a 45 degree angle so there is a slant at the bottom of the mesh where it is inside the tank, this will allow for better wicking and will ensure that your wick is always filled with juice.