Good RBA tank?

Status
Not open for further replies.

iamAuz

Senior Member
ECF Veteran
Verified Member
Apr 5, 2014
130
112
Bryant, Arkansas
kayfun is always a good choice. Kayfun Lite i guess you could go subohm if you wanted, it will do it. but dripping atomizer are prob better for subohm. also there is the Squape, Taifun, Aqua, Ithaka, Expromizer. those all have a tank that will hold juice, instead of having to drip juice all the time. personally i like my kayfun lite, its easy and doesnt give me any problems. when i am out of the house i use my kayfuns, while im at home i use my RDAs. choice is yours!
 
Last edited:

Btsmokincat

Ultra Member
ECF Veteran
Oct 10, 2013
1,987
2,354
Waterville ME
The new Fogger V4 has a glass tank and is made for a dual coil set-up, perfect for sub-ohms. I have a two Kayfun clones and an Aqua. The Aqua is much better suited for sub-ohms but it is tricky to build and fill. I like the vape from the aqua, the juice flow and air flow controls but it only holds maybe 2ml. I'll be getting a fogger at some point cause it looks much easier to build and fill!
 

DurtyZ

Senior Member
ECF Veteran
Jan 25, 2014
111
65
Utah
It depends on what you want.
Kayfun style RTA would be good if you wanted something which holds a lot of liquid. Good flavor and okay vapor production. Very easy to build

Genesis style rba if you want something that puts out a whole lot of vapor with really good flavor comparable to a dripper. Of course its a much steeper learning curve. But once you set it up right and get the hang of it, building any other kind of rebuildable is a piece of cake.
 

Dusif

Super Member
ECF Veteran
May 21, 2013
980
535
36
Denmark
The new Fogger V4 has a glass tank and is made for a dual coil set-up, perfect for sub-ohms. I have a two Kayfun clones and an Aqua. The Aqua is much better suited for sub-ohms but it is tricky to build and fill. I like the vape from the aqua, the juice flow and air flow controls but it only holds maybe 2ml. I'll be getting a fogger at some point cause it looks much easier to build and fill!

The trick to filling the aqua is to not close the air off but close the juice, when the o-ring hits the tank part but does not make a total seal, flip it upside down wait a sec or two and tighten, then wait a sec or two again and flip... Youre done...


__________________________
M16 helio 0,29
Galileo aqua 0,8
Bolt carto tank
Vamo vivi/protank
Kts+ igo-w 0,7
 
Status
Not open for further replies.

Users who are viewing this thread